  /**
  @addtogroup UART_WordSend UART_WordSend for MDR1986BE4 evaluation board
  @latexonly
  @verbatim
  ******************** (C) COPYRIGHT 2024 Milandr ******************************
  * @file    readme.txt
  * @author  Milandr Application Team
  * @version V2.1.1
  * @date    08/11/2024
  * @brief   Description of the UART_WordSend Example.
  ******************************************************************************
  * THE PRESENT FIRMWARE IS FOR GUIDANCE ONLY. IT AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING MILANDR'S PRODUCTS IN ORDER TO FACILITATE
  * THE USE AND SAVE TIME. MILANDR SHALL NOT BE HELD LIABLE FOR ANY
  * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES RESULTING
  * FROM THE CONTENT OF SUCH FIRMWARE AND/OR A USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN THEIR PRODUCTS.
  ******************************************************************************
  @endverbatim
  @endlatexonly

@par Example Description

This example shows how to use UART.
Configure PORTB lines 0,1 as UART1_TX,UART1_RX.
Configure PORTC lines 0,1 as UART2_TX,UART2_RX.
Configure UARTs on an exchange with 9600 Baud rate, 8 bit data size, 2 stop-bit and parity Even check.
Check TXFE flag before transmit.
UART2 transmit word.
Check RXFF flag before receive.
UART1 recive word.


@par Directory contains:

    - main.c                  Main program


@par Hardware and Software environment:

    - This example is intended to run on MDR1986BE4 eval board with MDR1986BE4 microcontroller.
    - Pins PB0 and PC1 should be connected; pins PB1 and PC0 should be connected.
    - HSE oscillator is used so it should be present.


@par How to use.

To launch the example, you must do the following:
    - Create a project and setup all project configurations.
    - Add main.c file.
    - Add the required files from "Library" folder:
        MDR32F9Qx_config.h
        MDR32F9Qx_port.c
        MDR32F9Qx_rst_clk.c
        MDR32F9Qx_uart.c
    - Edit the MDR32F9Qx_conf.h to set appropriate run-time parameter checking level.
    - Compile and link together all .c files and load your image into the target board.
    - Run the example.


 * <h3><center>&copy; COPYRIGHT 2024 Milandr</center></h3>
 */

